Makita KR401MP Original Instruction Manual

Also see for KR401MP: Original instruction manual Original instruction manual

Contents

general safety

6 ENGLISHPARTS DESCRIPTION142356789► 1. Cap 2. Pipe 3. Protector 4. Gear case 5. Rotorblade 6. Lock pin 7. Clip 8. Hub 9. HexalobularwrenchASSEMBLYWARNING: Before assembling or adjustingthe equipment, switch off the motor and removethe spark plug cap or battery cartridge. Otherwisethe cutting tool or other parts may move and result inserious injury.WARNING: Before handling the rotorblades, wear protective gloves. During the assem-bly or adjustment, your fingers may contact with therotor blade and it may cause serious injury.WARNING: When assembling or adjustingthe equipment, always put it down. Assembling oradjusting the equipment in an upright position mayresult in serious injury.WARNING: Follow the warnings and precau-tions in the chapter “SAFETY WARNINGS” andthe instruction manual of the power unit.Mounting the attachment pipeCAUTION: Always check that the attach-ment pipe is secured after installation. Improperinstallation may cause the attachment falling off fromthe power unit and cause personal injury.Mount the attachment pipe to the power unit.1. Turn the lever toward the attachment.1► 1. Lever2. Align the pin with the arrow mark. Insert theattachment pipe until the release button pops up. Makesure that the position line is on the tip of the arrow mark.1234► 1. Release button 2. Arrow mark 3. Pin 4. Positionline3. Turn the lever toward the power unit.1► 1. LeverMake sure that the surface of the lever is parallel to thepipe.NOTICE: Do not tighten the lever without theattachment pipe inserted. Otherwise the lever maytighten the entrance of the drive shaft too much anddamage it.