Makita HW1200 Instruction Manual

Also see for HW1200: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

9 ENGLISHCAUTION: Stay alert to the rebound of thewater jet and blown objects. Do not bring thenozzle to the object closer than 30 cm (1 ft).CAUTION: Do not run the high pressurewasher without water for longer than 1 minute.CAUTION: Do not operate the high pressurewasher for a extended period of time. This maycause overheating or fire. Also, long-term use maycause vibration disorder.CAUTION: Be aware of the direction of thewind. If the detergent gets into your eyes or mouth,rinse with fresh water immediately and seek medicalattention if necessary.NOTICE: Avoid using the high pressure washerfor longer than 1 hour. After using it for 1 hour,leave a same length of intermission.1. Connect the end of the high-pressure hose to thetrigger gun. For the HW1200, connect the other end tothe high pressure washer. For the HW1300, unreel thehose all the way to the end.2. Connect the high pressure washer to the faucetand then open the faucet.NOTICE: To protect the mechanism of the highpressure washer, do not use water hotter than40°C.3. Plug the high pressure washer into the mains andswitch it on.1► 1. Power switch4. To eject a water jet, unlock the stopper andsqueeze the trigger. The jet continues as long as thetrigger is squeezed.1► 1. StopperCAUTION: Hold the trigger gun firmly. Thetrigger gun recoils when you pull the trigger.CAUTION: Always hold the trigger gun by thegrip and barrel when cleaning. While the motor isrunning, do not touch any part of the high pres-sure washer body other than the carrying handleand power switch.NOTICE: Be careful not to pull the trigger gunforcibly during operation. It may cause the highpressure washer to fall over.After operatingCAUTION: After operating, always performthe procedure described in this manual. Residualpressure in the trigger gun or high pressure washercan cause personal injury or damage to the pumpinside.1. After operating, leave the power switch on.2. Close the faucet and disconnect the water hosefrom the high pressure washer.