Makita HR3011FC Instruction Manual

Also see for HR3001C: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

4 ENGLISH8. Always be sure you have a firm footing. Besure no one is below when using the tool inhigh locations.9. Hold the tool firmly with both hands.10. Keep hands away from moving parts.11. Do not leave the tool running. Operate the toolonly when hand-held.12. Do not point the tool at any one in the areawhen operating. The bit could fly out andinjure someone seriously.13. Do not touch the bit, parts close to the bit, orworkpiece immediately after operation; theymay be extremely hot and could burn yourskin.14. Some material contains chemicals which maybe toxic. Take caution to prevent dust inhala-tion and skin contact. Follow material suppliersafety data.15. Do not touch the power plug with wet hands.SAVE THESE INSTRUCTIONS.WARNING: DO NOT let comfort or familiaritywith product (gained from repeated use) replacestrict adherence to safety rules for the subjectproduct. MISUSE or failure to follow the safetyrules stated in this instruction manual may causeserious personal injury.SymbolsThe followings show the symbols used for tool.voltsampereshertzalternating currentno load speedClass II Constructionrevolutions or reciprocation per minutenumber of blowPower supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, andcan only be operated on single-phase AC supply.FUNCTIONALDESCRIPTIONCAUTION: Always be sure that the tool isswitched off and unplugged before adjusting orchecking function on the tool.Switch actionCAUTION: Before plugging in the tool, alwayscheck to see that the switch trigger actuatesproperly and returns to the "OFF" position whenreleased.To start the tool, simply pull the switch trigger. Toolspeed is increased by increasing pressure on the switchtrigger. Release the switch trigger to stop.1► 1. Switch triggerLighting up the front lampFor HR3011FC, HR3012FC onlyCAUTION: Do not look in the light or see thesource of light directly.To turn on the lamp, pull the switch trigger. Release theswitch trigger to turn it off.1► 1. LampNOTE: Use a dry cloth to wipe the dirt off the lens ofthe lamp. Be careful not to scratch the lens of lamp, orit may lower the illumination.