Makita EA3500F Operator's And Safety Manual

Also see for EA3500F: Repair manual Repair manual Instruction manual Instruction manual

Makita EA3500F Operator's And Safety Manual Manual pdf 25 page image

2512347986 5STOPMounting the guide bar and saw chainPlace the saw on a stable surface and perform the followingwork steps in order to install the guide bar and saw chain:Release the chain brake by pulling the hand guard (1) in direc-tion of arrow.Fold up the sprocket guard quick tensioner (2) (see also theillustration on tensioning the saw chain).Push the sprocket guard quick tensioner in forcefully againstthe spring tension and slowly turn counter-clockwise, untilyou feel it engage. Keep pushing, and turn as far as possiblecounter-clockwise.Release the sprocket guard quick tensioner again and turnclockwise to bring it back to its original position. Repeat thisprocedure until the sprocket guard (4) is unscrewed.Remove the sprocket guard (4).Lift the chain (8) over the sprocket (7).CAUTION:Do not insert the chain between the chain sprocket and thedisc.Guide the chain from above about halfway into the groove (9)on the guide bar.CAUTION:Note that the cutting edges along the top of the chain mustpoint in the direction of the arrow!Put the guide bar (5) on and push it against the sprocket (6).Only for models with quick tensioneron sprocket guardCAUTION:Before doing any work on the guide bar or chain, alwaysswitch off the engine and pull the plug cap off the sparkplug (see „Replacing the spark plug“). Always wear protec-tive gloves!CAUTION:Start the chain saw only after having assembled it com-pletely and inspected.