Makita DS4012 Instruction Manual

Also see for DS4012: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

3 ENGLISHENGLISH (Original instructions)SPECIFICATIONSModel: DS4012Drilling capacities Steel 13 mmWood 36 mmNo load speed 0 - 600 min -1Overall length 340 mmNet weight 2.8 - 3.0 kgSafety class /II• Due to our continuing program of research and development, the specifications herein are subject to change without notice.• Specifications may differ from country to country.• The weight may differ depending on the attachment(s). The lightest and heaviest combination, according toEPTA-Procedure 01/2014, are shown in the table.Intended useThe tool is intended for drilling in wood, metal and plastic.Power supplyThe tool should be connected only to a power supply of the samevoltage as indicated on the nameplate, and can only be operatedon single-phase AC supply. They are double-insulated and can,therefore, also be used from sockets without earth wire.NoiseThe typical A-weighted noise level determined accord-ing to EN62841-2-1:Sound pressure level (LpA) : 83 dB (A)Sound power level (LWA) : 90 dB (A)Uncertainty (K) : 3 dB (A)NOTE: The declared noise emission value(s) has beenmeasured in accordance with a standard test methodand may be used for comparing one tool with another.NOTE: The declared noise emission value(s) mayalso be used in a preliminary assessment of exposure.WARNING: Wear ear protection.WARNING: The noise emission during actualuse of the power tool can differ from the declaredvalue(s) depending on the ways in which the tool isused especially what kind of workpiece is processed.WARNING: Be sure to identify safety measuresto protect the operator that are based on an estima-tion of exposure in the actual conditions of use (tak-ing account of all parts of the operating cycle suchas the times when the tool is switched off and whenit is running idle in addition to the trigger time).VibrationThe vibration total value (tri-axial vector sum) deter-mined according to EN62841-2-1:Work mode: drilling into metalVibration emission (ah,D) : 8.5 m/s2Uncertainty (K) : 1.5 m/s2NOTE: The declared vibration total value(s) has beenmeasured in accordance with a standard test methodand may be used for comparing one tool with another.NOTE: The declared vibration total value(s) may alsobe used in a preliminary assessment of exposure.WARNING: The vibration emission during actualuse of the power tool can differ from the declared val-ue(s) depending on the ways in which the tool is usedespecially what kind of workpiece is processed.WARNING: Be sure to identify safety mea-sures to protect the operator that are based on anestimation of exposure in the actual conditions ofuse (taking account of all parts of the operatingcycle such as the times when the tool is switchedoff and when it is running idle in addition to thetrigger time).Declarations of ConformityFor European countries onlyThe Declarations of conformity are included in Annex Ato this instruction manual.SAFETY WARNINGSGeneral power tool safety warningsWARNING: Read all safety warnings, instruc-tions, illustrations and specifications providedwith this power tool. Failure to follow all instructionslisted below may result in electric shock, fire and/orserious injury.Save all warnings and instruc-tions for future reference.The term "power tool" in the warnings refers to yourmains-operated (corded) power tool or battery-operated(cordless) power tool.