Makita DML815 Instruction Manual

3 ENGLISHENGLISH (Original instructions)SPECIFICATIONSModel: DML815LED 0.5 W x 4Dimensions(L x W x H)227 mm x 79 mm x 116 mmRated voltage D.C. 14.4/18 VNet weight 0.56 - 0.93 kgBattery cartridge BL1415N / BL1430 / BL1430B / BL1440 / BL1450 / BL1460BBL1815N / BL1820 / BL1820B / BL1830 / BL1830B / BL1840 /BL1840B / BL1850 / BL1850B / BL1860B• Due to our continuing program of research and development, the specifications herein are subject to change without notice.• Specifications may differ from country to country.• Some of the battery cartridges listed above may not be available depending on your region of residence.• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-est combination, according to EPTA-Procedure 01/2014, are shown in the table.Operating timeBattery cartridge Operating timeBL1430 / BL1430B 17 hoursBL1460B 35 hoursBL1830 / BL1830B 24.5 hoursBL1860B 54 hours• The operating times in the above table are a roughguideline. They may differ from actual operating times.SymbolsThe followings show the symbols used for the equipment.Be sure that you understand their meaning before use.Read instruction manual.Indoor use only.Ni-MHLi-ionOnly for EU countriesDo not dispose of electric equipment orbattery pack together with household wastematerial!In observance of the European Directives,on Waste Electric and Electronic Equipmentand Batteries and Accumulators and WasteBatteries and Accumulators and their imple-mentation in accordance with national laws,electric equipment and batteries and batterypack(s) that have reached the end of their lifemust be collected separately and returned to anenvironmentally compatible recycling facility.Battery protection systemThe tool is equipped with the protection system, whichautomatically cuts off the output power for long service life.The light goes off during operation when the remaining bat-tery capacity gets low. This is caused by the activation ofthe protection system and does not show trouble. Removethe battery cartridge from the tool and charge it.SAFETY WARNINGSIMPORTANT SAFETY INSTRUCTIONSWARNING: When using electric tools, basicsafety precautions should always be followed toreduce the risk of fire, electric shock, and per-sonal injury, including the following:READ ALL INSTRUCTIONS.1. Do not look into the light, or do not expose thelight to eyes. Eyes may be damaged.2. Do not cover or clog the lit tool with cloth or car-ton, etc. Covering or clogging it may cause a flame.3. The tool is not waterproof. Do not use it indamp or wet locations. Do not expose it to rainor snow. Do not wash it in water.4. Do not touch the inside of the flashlight headwith tweezers, metal tools, etc.5. Do not give the tool a shock by dropping,striking, etc.6. When the tool is not in use, always switch offand remove the battery cartridge from the tool.7. Battery tool use and care1. Recharge only with the charger specified bythe manufacturer. A charger that is suitable forone type of battery pack may create a risk of firewhen used with another battery pack.2. Use power tools only with specificallydesignated battery packs. Use of any otherbattery packs may create a risk of injury andfire.3. When battery pack is not in use, keep itaway from other metal objects, like paperclips, coins, keys, nails, screws or othersmall metal objects, that can make aconnection from one terminal to another.Shorting the battery terminals together maycause burns or a fire.