Menu
Makita DKP140 Instruction Manual
Also see for DKP140: Instruction manualInstruction manualInstruction manualInstruction manualInstruction manual
                |
8For tool with mini planer blades124 30117401. Remove the existing blade, if the tool has been inuse, carefully clean the drum surfaces and thedrum cover. To remove the blades on the drum,unscrew the three installation bolts with the socketwrench. The drum cover comes off together withthe blades.123456789100025652. To install the blades, loosely attach the adjustingplate to the set plate with the pan head screwsand set the mini planer blade on the gauge baseso that the cutting edge of the blade is perfectlyflush with the inside flank of the gauge plate.3. Set the adjusting plate/set plate on the gaugebase so that the planer blade locating lugs on theset plate rest in the mini planer blade groove, thenpress in the heel of the adjusting plate flush withthe back side of the gauge base and tighten thepan head screws.4. It is important that the blade sits flush with theinside flank of the gauge plate, the planer bladelocating lugs sit in the blade groove and the heelof the adjusting plate is flush with the back side ofthe gauge base. Check this alignment carefully toensure uniform cutting.5. Slip the heel of the adjusting plate into the grooveof the drum.12345670025666. Set the drum cover over the adjusting plate/setplate and screw in the three hex flange head boltsso that a gap exists between the drum and the setplate to slide the mini planer blade into position.The blade will be positioned by the planer bladelocating lugs on the set plate.7. The blade's lengthwise adjustment will need to bemanually positioned so that the blade ends areclear and equidistant from the housing on oneside and the metal bracket on the other.8. Tighten the three hex flange head bolts (with thesocket wrench provided) and rotate the drum tocheck clearances between the blade ends and thetool body.9. Check the three hex flange head bolts for finaltightness.10. Repeat procedures 1 - 9 for the other blade.1. Mini planer blade2. Groove3. Set plate4. Hex. flange headbolts5. Drum cover6. Drum7. Adjusting plate1. Pan head screw2. Adjusting plate3. Planer bladelocating lugs4. Gauge plate5. Heel ofadjusting plate6. Set plate7. Inside flank ofgauge plate8. Gauge base9. Back side ofgauge base10. Mini planer blade1. Socket wrench2. Bolt3. Loosen4. Tighten |
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved