Makita DJV142 Instruction Manual

Also see for DJV142: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Makita DJV142 Instruction Manual Manual pdf 9 page image

9Anti-splintering device21014121For splinter-free cuts, the anti-splintering device can beused. To install the anti-splintering device, move the toolbase all the way forward and fit it from the back of toolbase. When you use the cover plate, install the anti-splintering device onto the cover plate.CAUTION:• The anti-splintering device cannot be used whenmaking bevel cuts.Dust extractionThe dust nozzle (optional accessory) is recommendedto perform clean cutting operations.12013878To attach the dust nozzle on the tool, insert the hook ofdust nozzle into the hole in the base.1014122To secure the dust nozzle, tighten the clamp screw atthe front of the dust nozzle.The dust nozzle can be installed on either left or rightside of the base.12014117Then connect a Makita vacuum cleaner to the dust nozzle.OPERATIONCAUTION:• Always hold the base flush with the workpiece.Failure to do so may cause blade breakage,resulting in a serious injury.NOTE:• If the tool is operated continuously until the batterycartridge has discharged, allow the tool to rest for15 minutes before proceeding with a fresh battery.12014110Turn the tool on without the blade making any contactand wait until the blade attains full speed. Then rest thebase flat on the workpiece and gently move the toolforward along the previously marked cutting line.When cutting curves, advance the tool very slowly.Bevel cuttingCAUTION:• Always be sure that the tool is switched off and thebattery cartridge is removed before tilting the base.0141111. Cutting line2. Base1. Dust nozzle2. Hose for vacuumcleaner1. Clamp screw1. Dust nozzle2. Base1. Anti-splinteringdevice2. Base