Menu
Makita DGA405 Instruction Manual
Also see for DGA405: Instruction manualInstruction manualInstruction manualTechnical informationInstruction manual
                                                |
12WARNING:• When using an abrasive cut-off / diamond wheel,be sure to use only the special wheel guarddesigned for use with cut-off wheels.• NEVER use cut-off wheel for side grinding.• Do not "jam" the wheel or apply excessivepressure. Do not attempt to make an excessivedepth of cut. Overstressing the wheel increasesthe loading and susceptibility to twisting or bindingof the wheel in the cut and the possibility ofkickback, wheel breakage and overheating of themotor may occur.• Do not start the cutting operation in the workpiece.Let the wheel reach full speed and carefully enterinto the cut moving the tool forward over theworkpiece surface. The wheel may bind, walk upor kickback if the power tool is started in theworkpiece.• During cutting operations, never change the angleof the wheel. Placing side pressure on the cut-offwheel (as in grinding) will cause the wheel to crackand break, causing serious personal injury.• A diamond wheel shall be operated perpendicularto the material being cut.Operation with wire cup brush(optional accessory)CAUTION:• Check operation of brush by running tool with noload, insuring that no one is in front of or in linewith brush.• Do not use brush that is damaged, or which is outof balance. Use of damaged brush could increasepotential for injury from contact with broken brushwires.1015315Remove the battery cartridge from the tool and place itupside down allowing easy access to spindle. Removeany accessories on spindle. Thread wire cup brush ontospindle and tighten with supplied wrench. When usingbrush, avoid applying too much pressure which causesover bending of wires, leading to premature breakage.Operation with wire wheel brush(optional accessory)CAUTION:• Check operation of wire wheel brush by runningtool with no load, insuring that no one is in front ofor in line with the wire wheel brush.• Do not use wire wheel brush that is damaged, orwhich is out of balance. Use of damaged wirewheel brush could increase potential for injuryfrom contact with broken wires.• ALWAYS use guard with wire wheel brushes,assuring diameter of wheel fits inside guard.Wheel can shatter during use and guard helps toreduce chances of personal injury.1015316Remove the battery cartridge from the tool and place itupside down allowing easy access to spindle. Removeany accessories on spindle. Thread wire wheel brushonto spindle and tighten with the wrenches.When using wire wheel brush, avoid applying too muchpressure which causes over bending of wires, leading topremature breakage.MAINTENANCECAUTION:• Always be sure that the tool is switched off and thebattery cartridge is removed before attempting toperform inspection or maintenance.• Never use gasoline, benzine, thinner, alcohol orthe like. Discoloration, deformation or cracks mayresult.12015317The tool and its air vents have to be kept clean.Regularly clean the tool's air vents or whenever thevents start to become obstructed.1. Exhaust vent2. Inhalation vent1. Wire wheelbrush1. Wire cup brush |
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved