Makita DCS500 Instruction Manual

Also see for DCS460: Owner's and safety manual Repair manual Instruction manual Owner's and safety manual

Makita DCS500 Instruction Manual Manual pdf 22 page image

22723146 5ABCleaning the brake band and sprocket interiorCAUTION: Before doing any work on the guide bar or chain,always switch off the engine and pull the plug cap off thespark plug (see ÑReplacing the spark plugì). Always wearprotective gloves!CAUTION: Start the chain saw only after having assembledit completely and inspected.Remove the sprocket guard (1) (See ÑPUTTING INTO OPERA-TIONì figs. B) and clean the interior with a brush.Turn the chain tensioning screw (2) to the left (counter-clockwise)until pin (3) of the chain tensioner is underneath the threadedpin (4).Remove the chain (5) and guide bar (6).NOTE:Make sure there are no residues or foreign matter remaining inthe oil guide groove (7) or on the chain tensioner (3).For replacing the guide bar, chain, and sprocket see ÑPUTTINGINTO OPERATIONì.NOTE:The chain brake is a very important safety device and likeany other component subject to normal wear and tear.Regular inspection and maintenance are important foryour own safety and must be done by a MAKITA servicecentre.SERVICECleaning the guide barCAUTION: Protective gloves must be worn.Regularly inspect the bearing surfaces of the guide bar fordamage, and clean them with a suitable tool.