Makita DCS431 Owner's And Safety Manual

Also see for DCS 431: Spare parts Owner's and safety manual Instruction manual

Makita DCS431 Owner's And Safety Manual Manual pdf 29 page image

29Replacing the starter cable- Thread in a new cable (4 mm/.16" dia. x 1000 mm/39" long)as shown in Figure B and tie the ends as shown.- Pull knot (B/1) into the cable pulley (B/3).- Pull knot (B/2) into the cable grip (B/4).- Wind the cable around the pulley in the direction shown bythe arrow. Pull the cable out from the pulley by the grip, thenhold the pulley firmly and wrap the cable around it anotherthree times.CAUTION: Danger of injury! Secure the cable grip whenpulled out! It will whip back if the cable pulley is releasedby accident.NOTE: With the cable pulled all the way out, it must still bepossible to turn the pulley another 1/4 turn against the returnspring.Replacing the return spring- Remove the fan housing (see above under "Replacing thestarter cable").- Take off the circlip (C/1) and washer (C/2) (circlip pliers, see"Accessories").- Remove the cable pulley (C/3).- Unscrew screws (C/4) and carefully remove spring housing(C/5) with spring.CAUTION: Danger of injury! If the spring is broken it maypop out!NOTE:The old spring and spring housing should be recycled.Replacement springs come already installed in a new springhousing. Before installing, grease the spring lightly withmulti-purpose grease, order No. 944 360 000.- Assemble in reverse order. When putting the cable pulleyback on, turn it slightly until you feel it catch.- Wind on the starter cable as described above under "Re-placing the starter cable."Mounting the fan housing- Push the tab (D/1) extending out from the edge of the fanhousing (D/3) under the hood (D/2).- Position the screw holes.- Push the fan housing (D/3) gently and pull the starter gripuntil the starter catches.- Screw in the four fastening screws tightly.- Unscrew the four screws (A/1) holding down the fan hous-ing (A/2). Lift the housing slightly, pull in the direction of thearrow, and remove.- Remove all pieces of cable.ASTOP