Makita DA4030 Instructions Manual

Also see for DA4030: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

5ENGLISHExplanation of general view1 Tighten2 Chuck key3 Side grip4 Spade grip5 Wrench holder6 Loosen7 Hex wrench8 U mark9 Motor housing10 Lock button11 Handle12 Press13 Switch trigger14 Reversing switch lever15 A side16 Clockwise17 B side18 Counterclockwise19 Speed change knob20 Pointer21 Lock button22 Reaction23 Forward24 Drilling in forward bit turnsclockwise25 Reverse26 Reversing bit turnscounterclockwise27 Limit mark28 Screwdriver29 Brush holder capSPECIFICATIONSModel DA4030 DA4031Drilling capacitiesWoodAuger-bit .................................................................................38 mm 38 mmSelf-feed bit.............................................................................65 mm High: 65 mmLow: 118 mmHole saw ................................................................................. — 152 mmSteel ..........................................................................................13 mm 13 mmNo load speed (min -1 )...................................................................1,200 High: 1,200Low: 300Overall length ...............................................................................417 mm 462 mmOverall length (with an extended spade grip) ...............................491 mm 536 mmNet weight.....................................................................................4.8 kg 5.6 kg• Due to our continuing program of research and devel-opment, the specifications herein are subject to changewithout notice.• Note: Specifications may differ from country to country.Power supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, and canonly be operated on single-phase AC supply. They aredouble-insulated in accordance with European Standardand can, therefore, also be used from sockets withoutearth wire.Safety hintsFor your own safety, please refer to the enclosed safetyinstructions.SPECIFIC SAFETY RULESGEB001-2DO NOT let comfort or familiarity with product(gained from repeated use) replace strict adherenceto drill safety rules. If you use this power toolunsafely or incorrectly, you can suffer serious per-sonal injury.1. Use auxiliary handles supplied with the tool.Loss of control can cause personal injury.2. Hold tool by insulated gripping surfaces whenperforming an operation where the cutting toolsmay contact hidden wiring or its own cord.Contact with a “live” wire will make exposed metalparts of the tool “live” and shock the opeator.3. Always be sure you have a firm footing.Be sure no one is below when using the tool inhigh locations.4. Hold the tool firmly.5. Keep hands away from rotating parts.6. Do not leave the tool running. Operate the toolonly when hand-held.7. Do not touch the drill bit or the workpiece imme-diately after operation; they may be extremelyhot and could burn your skin.8. Some material contains chemicals which may betoxic. Take caution to prevent dust inhalationand skin contact. Follow material supplier safetydata.SAVE THESE INSTRUCTIONS.WARNING:MISUSE or failure to follow the safety rules stated inthis instruction manual may cause serious personalinjury.OPERATING INSTRUCTIONSInstalling or removing drill bit (Fig. 1)CAUTION:Always be sure that the tool is switched off andunplugged before installing or removing the bit.To install the bit, place it in the chuck as far as it will go.Tighten the chuck by hand. Place the chuck key in eachof the three holes and tighten clockwise. Be sure totighten all three chuck holes evenly. To remove the bit,turn the chuck key counterclockwise in just one hole,then loosen the chuck by hand. After using the chuck key,be sure to return it to the original position.