Makita AF550H Instruction Manual

7ENGLISH (Original instructions)Explanation of general viewSPECIFICATIONS• Due to our continuing program of research and development, the specifications herein are subject to change withoutnotice.• Specifications may differ from country to country.• Weight according to EPTA-Procedure 01/2003Symbols END106-3The following show the symbols used for the equipment.Be sure that you understand their meaning before use.......... Read instruction manual.......... Wear safety glasses...................... Do not use on scaffoldings, ladders.Intended use ENE073-1The tool is intended for fastening on interior work andfurniture work.Pneumatic nailer/stapler safetywarnings ENB110-4WARNING: Read all safety warnings and allinstructions. Failure to follow the warnings andinstructions may result in serious injury, electric shockand/or fire.Save all warnings and instructions forfuture reference.For personal safety and proper operation andmaintenance of the tool, read this instruction manualbefore using the tool.General safety• Do not permit those uninstructed to use the tool.• No horseplay. Respect the tool as a workingimplement.• Do not operate when under the influence of alcohol,drugs or the like.• Never alter the tool.Personal protective equipments• Always wear safety glasses to protect your eyes fromdust or fastener injury.WARNING: It is an employer’s responsibility toenforce the use of safety eye protection equipment bythe tool operators and by other persons in theimmediate working area.For Australia and New Zealand onlyAlways wear safety glasses and face shield to protectyour eyes from dust or fastener injury. The safetyglasses and the face shield should conform with therequirements of AS/NZS 1336. (Fig. 1)• Wear hearing protection to protect your ears againstexhaust noise and head protection. Also wear light butnot loose clothing. Sleeves should be buttoned orrolled up. No necktie should be worn.1. Safety glasses2. Face shield3. Compressor air output per minute4. Nailing frequency (times/min.)5. Locking position6. Released position7. Lock lever8. Trigger9. Contact element10. Adjuster11. Too deep12. Flush13. Too shallow14. Lever15. Sliding door16. Magazine17. Nail18. Groove for the sliding door19. Grooves at the bottom of themagazine20. Nail discharge opening21. Front driver guide22. Nose adapter23. Protrusion24. Holder25. Nose adapter26. Place first the contact elementagainst workpiece.27. Hex wrench28. Rear driver guide29. Screws30. Humid31. Hot32. Cap33. Drain cock34. Thinner35. StoveModel AF550HAir pressure 0.98 - 2.26 MPa (9.8 - 22.6 bar)Nail length 15 mm - 55 mmNail capacity 100 pcs.Pneumatic tool oil ISO VG32 or equivalentDimensions (L X H X W) 228 mm X 61 mm X 235 mmMin. hose diameter 5.0 mm or moreNet weight 1.3 Kg