Menu
Makita 4112H Instruction Manual
Also see for 4112H: Instruction manualParts BreakdownInstruction manualInstruction manualTechnical information
                            | |
6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking functionon the tool.Adjusting the depth of cut132004377Loosen the wing bolt on the depth guide and move thebase up or down. At the desired depth of cut, secure thebase by tightening the wing bolt.Only case you adjust the cutting depth to the maximumone, always be sure to do the adjustment afteradjustment of the wheel guard.Securing wheel guard12004014CAUTION:• The wheel guard must be adjusted on the tool sothat the closed side of the guard always pointstoward the operator.The wheel guard can be adjusted about 80 degrees,after you loosen the clamping nut. Adjust to the desiredangle, then secure the clamping nut.Switch action12AB004015CAUTION:• Before plugging in the tool, always check to seethat the switch trigger actuates properly andreturns to the "OFF" position when released.For tool with the lock-on switch (for other than USand Canada model)CAUTION:• Switch can be locked in "ON" position for ease ofoperator comfort during extended use. Applycaution when locking tool in "ON" position andmaintain firm grasp on tool.To start the tool, simply pull the switch trigger. (Adirection) Release the switch trigger to stop.For continuous operation, pull the switch trigger (Adirection), push in the lock lever(B direction) and thenrelease the switch trigger.To stop the tool from the locked position, pull the switchtrigger (A direction) fully, then release it.For tool with the lock-off switch (for US and Canadamodel)CAUTION:• Do not pull the switch trigger hard without pressingthe lock lever. This can cause switch breakage.To prevent the switch trigger from accidentally pulled, alock lever is provided.To start the tool, push in the lock lever (in the Bdirection) and then pull the switch trigger (in the Adirection). Release the switch trigger to stop.ASSEMBLYCAUTION:• Always be sure that the tool is switched off andunplugged before carrying out any work on thetool.1. Switch trigger2. Lock lever1. Clamping nut2. Wheel guard1. Wing bolt2. Base3. Cutting depth |
Related manuals for Makita 4112H
Makita 4112H Instruction Manual
Makita 4112H Instruction Manual
Makita 4112H Instruction Manual
Makita 4112HS Instruction Manual
Makita 4112HS Instruction Manual
Makita 4112HS Instruction Manual
Makita 4112HS Instruction Manual
Makita 4112HS Instruction Manual
Makita 4112HS Instruction Manual
Makita 4112HS Instruction Manual
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved