Makita 3606 Instruction Manual

Also see for 3606: Instruction manual Parts Breakdown Instruction manual Instruction manual Instruction manual

Contents

612 34001985Straight guide (optional accessory)003676The straight guide is effectively used for straight cutswhen chamfering or grooving.Screw the guide bars into the holes in the tool base.12003680Install the straight guide on the guide bars and adjustthe distance between the bit and the straight guide. Atthe desired distance, tighten the wing bolts to securethe straight guide in place.1 23003681When cutting, move the tool with the straight guide flushwith the side of the workpiece.Templet guide (optional accessory)003687The templet guide provides a sleeve through which thebit passes, allowing use of the tool with templet patterns.To install the templet guide, loosen the screws on the toolbase, insert the templet guide and then tighten the screws.1 23003691Secure the templet to the workpiece. Place the tool onthe templet and move the tool with the templet guidesliding along the side of the templet.1234 567003695NOTE:• The workpiece will be cut a slightly different sizefrom the templet. Allow for the distance (X)between the bit and the outside of the templetguide. The distance (X) can be calculated by usingthe following equation:Distance (X) = (outside diameter of the templetguide - bit diameter) / 21. Bit2. Base3. Templet4. Workpiece5. Distance (X)6. Outsidediameter of thetemplet guide7. Templet guide1. Base plate2. Templet guide3. Screw1. Straight guide2. Guide bar3. Wing bolt1. Screwdriver2. Guide bar1. Feed direction2. Bit revolvingdirection3. Workpiece4. Straight guide