Mag-Torch MT790 Instruction Manual

Mag-Torch MT790 Instruction Manual Manual pdf 1 page image

ENGFRAESPPORDANGERDANGERPELIGROPERIGOFIREINCENDIEFUEGOINCÊNDIOEXPLOSIONEXPLOSIONEXPLOSIÓNEXPLOSÃOFUMESVAPEURSVAPORESVAPORESInstruction ManualEXTREMELY FLAMMABLE. CONTENTS UNDER PRESSURE.• Take precautions not to heat fuel tank.• Contains flammable gas under pressure. Do not expose the torch or fuel to temperatures exceeding 120°F/49°C or prolonged sunlight.• Never use torch in or around flammable fumes, liquids, or explosive materials.• Never pierce fuel tank or expose torch to fire.• Do not breathe gas, fumes, vapor or spray. If inhaled, remove affected person to fresh air.• Avoid contact with eyes or skin. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. For skin contact, flush withlarge amounts of water.• Do not modify torch in any way. Do not alter factory settings. Serious injury or death can result from adjusting factory settings or modifying factory fittedparts. Always use manufacturer recommended replacement parts.• Read and understand refueling instruction before refueling torch. Refueling the torch incorrectly can result in serious injury or death.WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects orother reproductive harm. For more information go to www.P65Warnings.ca.gov. Wash hands after handling.• Keep torch out of reach of children and anyone who has not read instructions. Do not point torch towards face, other persons or flammable objects. Neverattempt to use torch as a cigarette lighter• Always wear eye protection and gloves when lighting and using the torch.• To avoid risk of damage to torch, always protect torch from impact and never allow torch to drop onto floor or hard surfaces. Never use a torch thatappears to be damaged.• Heating a surface may cause heat to be conducted to adjoining surfaces that may be combustible or become pressurized when heated. Always check tomake sure no unintended parts or materials are being heated.• Do not use a leaking, damaged or malfunctioning torch. If torch is leaking, contact manufacturer or retailer.• Work only in well ventilated areas. Avoid the fumes from fluxes, lead-based paint, and all metal heating operations. Be careful to avoid fumes fromcadmium plating and galvanized metal- remove these coatings in the area to be heated by filing or sanding prior to heating.• Ignite torch away from face, hands, clothing, or other flammable material.• Extremely hot air escapes from exhaust ports on soldering tip assembly. Always rest torch on the stand supplied, even during short breaks, to avoid riskof damaging work surfaces or other flammable items. Extinguish torch during longer breaks. Never point exhaust ports toward eyes, face, hands, or otherflammable items.• Use caution when operating the torch outdoors on sunny or windy days. Bright sun makes it impossible to see the torch’s flame. Wind may carry thetorch’s heat back towards you or other areas not intended to be heated. Windy conditions may also cause sparks to be blown into other areas withcombustible materials.• Burner nozzle and tip assembly become extremely hot during use and remain hot after extinguishing the torch. Take precautions not to touch torch tip untiltorch has cooled.• Never use the torch on or near combustibles (fuels, rags, towels, paper products, etc.). Be careful around motor vehicles or any gasoline-fired productsand beware of hidden fuel lines and tanks.• Always make certain the torch is resting on level surface to reduce the risk of accidental tip over. Be sure the torch is not pointed in a direction whichcould cause nearby objects to ignite when the torch is set down.• Never leave the torch unattended when lit.• Never attempt to repair or heat a gasoline tank, a chemical drum an aerosol can, a compressed gas container that held flammable liquid or gas or anyother chemical. Heating these is extremely dangerous, especially after they have been “emptied”.• Department of Transportation Hazardous Materials Regulations forbids the carriage of butane or other flammable gas products on passenger aircraft. Donot pack this item or any other flammable gas item in any checked or carry-on baggage.• Make sure torch is completely extinguished after use.• Ensure that torch is completely cool before storing.• Always have a fire extinguisher and a bucket of water near the torch and work area.ENGLISH | ANGLAIS | INGLÉS | INGLÊSModels: MT790DANGERThis torch is used with a flammable product. Failure tocomply with these warnings and instructions may resultin an explosion or fire that may cause property damage,serious personal injury or death.Read and comply with the instructions and warnings in thismanual and familiarize yourself with the torch before lightingand using. Review instructions and warnings periodically tomaintain awareness. Do not try to operate before readinginstructions.DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS | NE PAS JETER CES AVERTISSEMENTS ET CES INSTRUCTIONSNO DESECHE ESTAS ADVERTENCIAS E INSTRUCCIONES | NÃO DESCARTE ESTES AVISOS DE ATENÇÃO E INSTRUÇÕES13 1115121417 16