Macrom M-DVD6560 User Manual

Macrom M-DVD6560 User Manual Manual pdf 8 page image

- 6 -Select Preset Equalizer1. Enter the EQ setup modeTouch the [ ] icon in the user interface and theEQ setup interface will display on the screen.2. Select EQ modeTouch the desired EQ selection: [ Optimal ] /[ Classic ] / [ Rock ] / [ Jazz ] / [ Techno ] / [ Pop ],and the EQ mode will change.Adjust EQ ParametersTo adjust EQ parameters, touch and drag the parameters adjustment bar.[ User ]: Set the desired audio effect.[ Flat ]: Select the original audio effect.[ Reset ]: Cancel the equalizer function settings.[ Loud: On/Off ]: When listening to music at low volumes, this featurewill selectively boost certainbass and treble frequencies.Adjust FAD BALYou can adjust front/back/left/right balance of the speaker and the subwoofer volume to getbalanced listening effect according to the surroundings and your interest.1. Enter the EQ setup modeTouch the [ ] icon in the user interface and the EQsetup interface will display on the screen.2. Adjust subwoofer volumeTouch [ ] / [ ] or drag [ ] to adjust subwoofervolume from -12 to +12.3. Adjust fader / balance valueTouch [ ] / [ ] / [ ] / [ ] to adjust fader /balance value from -20 to +20.[ ]: Front speaker[ ]: Rear speaker[ ]: Left speaker[ ]: Right speakerBasic OperationsEQ MenuThe Audio Control feature allows you to easily adjust your audio system to meet the acousticalcharacteristics of your vehicle, which vary depending on the type of vehicle and its measurements.Proper setting of the Fader and Balance boosts the effects of the cabin equalizer.Notes:1. The parameters of the EQ modes has been preset and you can not change them besides ‘User’.2. The EQ mode will change to ‘User’ automatically when you adjust the frequency value under themodes besides ‘User’.3. The value of Sub is independent of EQ mode and can be adjusted separately.M-DVD6560 User manual_ENG.indd 6 23/05/2014 14:36:27