APPENDIX A: FIBRE C HANNEL CONNECTED STORAGE D EVICE I NSTALL THE UNITM86 S ECURITY INSTALLATION G UIDE 123Install the UnitLink the SR Unit with the Fibre Channel ConnectedDeviceThis step is a continuation from the Storage Device Setup (for Attached StorageUnits) portion of Step 1A or 1B in the SR section. The procedures outlined in thisstep require the use of a CAT-5E crossover cable and the fibre channel cable.A. Plug one end of the CAT-5E crossover cable into the SR unit’s LAN 3 port-—theport on the upper right section on the rear of the SR unit (see Figure 1, LAN3port on a 730 model).B. Plug the fibre channel cable into the port on the lower right section on the rearof the SR unit (see Figure 1, fibre channel port on a 730 model).Figure 1: Diagram showing right portion of SR 730 chassis rearNOTE: The LAN3 port and fibre channel port on an IBM model 735 are also located at theright side on the rear of the chassis.C. Plug the other end of the fibre channel cable into the storage device’s HOST “1”channel (see Figure 2, Item A).Figure 2: Back of the Nexsan SATABoyD. Plug the other end of the CAT-5E crossover cable into the storage device’s NET“0” (zero) port (see Figure 2, Item B).E. Plug the storage device’s AC power cords into the rear sections of the unit (seeFigure 2, Item C).
