M2M Cellular GatewayIndex skipping is used to reserve slots for new function insertion, when required.131.6.3 Connecting PowerThe IDG701‐0T001 can be powered by connecting a power source to the terminal block . It supportsdual 9 to 48VDC power inputs. Following picture is the power terminal block pin assignments. Pleasecheck carefully and connect to the right power requirements and polarity.There are a DC converter and a DC12V/2A power adapter4 in the package for you to easily connect DCpower adapter to this terminal block.WARNNING: This commercial‐grade power adapter is mainly for ease of powering up the purchaseddevice while initial configuration. It’s not for operating at wide temperature range environment.PLEASE PREPARE OR PURCHASE OTHER INDUSTRIAL‐GRADE POWER SUPPLY FOR POWERING UP THEDEVICE.1.6.6 Connecting to the Network or a HostThe IDG701 series provides four RJ45 ports to connect 10/100Mbps Ethernet. It can auto detect thetransmission speed on the network and configure itself automatically. Connect the Ethernet cable tothe RJ45 ports of the device. Plug one end of an Ethernet cable into your computer’s network port andthe other end into one of IDG701 series for LAN ports on the front panel. If you need to configure ortroubleshoot the device, you may need to connect the IDG701 series directly to the host PC. In this way,you can also use the RJ45 Ethernet cable to connect the IDG701 series to the host PC’s Ethernet port.4 The maximum power consumption of IDG701‐0T001 is 15.5W.