Lenovo ThinkStation P710 User Manual

Also see for ThinkStation P510: Hardware Maintenance Manual Hardware configuration Configuration manual

Contents

Note: For some keyboards, you might need to press Fn+F10 to exit the Setup Utility program.When the ErP LPS compliance mode is enabled, you can wake up your computer by doing one of thefollowing:• Press the power button.• Enable the Wake Up on Alarm feature to make your computer wake up at a set time. See “Enabling ordisabling the automatic power-on of your computer” on page 38.• Enable the After Power Loss feature to make your computer wake up when the power supply resumesafter a sudden loss of electricity.To enable the After Power Loss feature, do the following:1. Start the Setup Utility program. See “Starting the Setup Utility program” on page 37.2. Select Power ➙ After Power Loss and press Enter.3. Select Power On and press Enter.4. To save settings and exit the Setup Utility program, press F10, select Yes in the window displayed,and press Enter.Note: For some keyboards, you might need to press Fn+F10 to exit the Setup Utility program.Enabling or disabling the configuration change detectionWhen the configuration change detection is enabled, if the POST detects configuration changes of somehardware devices (such as storage drives or memory modules), an error message is displayed.To enable or disable the configuration change detection, do the following:1. Start the Setup Utility program. See “Starting the Setup Utility program” on page 37.2. Select Security ➙ Configuration Change Detection and press Enter.3. Select the desired setting and press Enter.4. To save settings and exit the Setup Utility program, press F10, select Yes in the window displayed,and press Enter.Note: For some keyboards, you might need to press Fn+F10 to exit the Setup Utility program.To bypass the error message and log in to the operating system, do one of the following:• Press the F2 key.Note: For some keyboards, you might need to press Fn+F2 to bypass the error message.• Start and then exit the Setup Utility program. See “Starting the Setup Utility program” on page 37 and“Exiting the Setup Utility program” on page 42.Changing the BIOS settings before installing a new operating systemBIOS settings vary by operating system. Change the BIOS settings before installing a new operating system.To change the BIOS settings, do the following:1. Start the Setup Utility program. See “Starting the Setup Utility program” on page 37.2. From the Setup Utility program main menu, select Exit ➙ OS Optimized Default.3. Depending on the operating system to be installed, do one of the following:• To install the Windows 10 (64-bit) operating system, select Enabled.• To install an operating system other than Windows 10 (64-bit), select Disabled.Chapter 5. Advanced configuration 39