Menu
Lenovo ThinkStation P410 User Manual
Also see for ThinkStation P410: Hardware Maintenance Manual
                                                                                                                          |
5. Ensure that the new power supply assembly is the correct replacement.6. Install the new power supply assembly into the chassis so that the screw holes in the power supplyassembly align with those in the chassis.7. Install and tighten the four screws to secure the power supply assembly.Note: Use only screws provided by Lenovo.8. Connect the power supply assembly cables to the system board and each of the drives.9. Secure the power supply assembly cables with the cable clips and ties in the chassis.What to do next:• To work with another piece of hardware, go to the appropriate section.• To complete the installation or replacement, go to “Completing the parts replacement” on page 87.Heat sink and fan assemblyAttention: Do not open your computer or attempt any repair before reading and understanding the “Readthis first: Important safety information” on page v.CAUTION:The heat sink and fan assembly might be very hot. Before you open the computer cover, turn off thecomputer and wait several minutes until the computer is cool.To replace the heat sink and fan assembly, do the following:1. Prepare your computer. See “Preparing your computer and removing the computer cover” on page 57.2. Lay the computer on its side for easier access to the system board.3. Locate the heat sink and fan assembly. See “Parts on the system board” on page 5.4. Disconnect the heat sink and fan assembly cable from the microprocessor fan connector on the systemboard. See “Parts on the system board” on page 5.Chapter 7. Installing or replacing hardware 79 |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved