Chapter 2. 2-8Adjusting your monitor imageThis section describes the user control features used to adjust your monitor image.Using the user controlsYour monitor has four user controls on the front panel. To locate the user controls, see "Locatingconnectors and controls on your monitor"on page 1-3. You can use the user controls to adjust somesettings of your monitor on the On Screen Display (OSD) main menu.• Back buttonUsed to move back and exit from the OSD menu.• Left shift button / Mode-switching buttonUsed to move to the left on the OSD menu and switch between the AIO mode (using the Tinyinstalled) and the DP mode (using an external desktop/laptop computer).• Right shift button / brightness controlUsed to move to the right on the OSD menu and adjust the brightness.• Selection button / menu-opening buttonUsed to open the OSD main menu and select an option.Using the OSD controlsThe settings adjustable with the user controls are viewed through the OSD, as shown below.Note: When switching to AIO mode, the monitor and the Tiny share the same power button on themonitor, However, if the enhanced power saving mode is enabled in the BIOS of the Tiny, you canonly use the power button of the computer to turn on the computer.To use the controls:1. Press to open the main OSD menu.2. Use or to move among the icons. Select an icon and press to access thatfunction. If there is a sub-menu, you can move between options using or , thenpress to select that function. Use or to make adjustments 3ress to save.3. Press to move backwards through the sub-menus and exit from the OSD.4. Press and hold for 10 seconds to lock the OSD. This will prevent accidentaladjustments to the OSD. Press and hold for 10 seconds to unlock the OSD and allowadjustments to the OSD.5. Enables DDC/CI by default. Use OSD Left Arrow Key, press and hold the buttons for 5seconds to disable/enable DDC/CI function. The words "DDC/CI Disable/DDC/CI/Enable" shows on the screen.ExitAdjusts overall screen Brightness/Contrast/DCROK