4. Install the new card into the appropriate card slot on the system board. See“Locating parts on the system board” on page 11. If you are replacing an oldPCI card, remove the old card currently installed before installing the new one.Notes:a. The card fits tightly into the card slot. If necessary, alternately move eachside of the card a small amount until it is fully removed from the card slot.b. If the card is held in place by a retaining latch, press the card retaining latch1 as shown to disengage the latch. Grasp the card and gently pull it outof the slot.Figure 10. Removing the old cardChapter 2. Installing options and replacing hardware 19