Lenovo ServeRAID M1210 Quick Installation Manual

Quick Installation GuideServeRAID M1210 SAS/SATA Controller for Lenovo System xThank you for purchasing the ServeRAID M1210 SAS/SATA Controller(hereafter referred to as controller) for Lenovo® System x. Before youinstall the controller, take a few minutes to read this quick installationguide.For more information about the controller, refer to theServeRAID M1210 SAS/SATA Controller for Lenovo Systemx User’s Guide on the ServeRAID matrix Web site athttps://support.lenovo.com/us/en/documents/serv-raid.Technical support: To get assistance for installing, configuring, orusing the controller, go to http://www.lenovo.com/support.DANGERElectrical current from power, telephone, and communication cables is hazardous.To avoid a shock hazard:• Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration of thisproduct during an electrical storm.• Connect all power cords to a properly wired and grounded electrical outlet.• Connect to properly wired outlets any equipment that will be attached to this product.• When possible, use one hand only to connect or disconnect signal cables.• Never turn on any equipment when there is evidence of fire, water, or structural damage.• Disconnect the attached power cords, telecommunications systems, networks, and modems before youopen the device covers, unless instructed otherwise in the installation and configuration procedures.• Connect and disconnect cables as described in the following table when installing, moving, or openingcovers on this product or attached devices.To Connect: To Disconnect:1. Turn everything OFF.2. First, attach all cables to devices.3. Attach signal cables to connectors.4. Attach power cords to outlet.5. Turn device ON.1. Turn everything OFF.2. First, remove power cords from outlet.3. Remove signal cables from connectors.4. Remove all cables from devices.1

/ 4

Related manuals for Lenovo ServeRAID M1210