Lenovo Storage S3200 withFibre ChannelQuick Start GuideBryan ReeseDavid VestalJeff LinJuly 2016©2016 Lenovo. All rights reserved.

solution overview

bill of materials

Lenovo S3200 Quick Start Manual

About this guide

CNC ports used for host connection

Document conventions and symbols

Components

drive enclosure front panel components

Disk drives used in S3200/S2200 enclosures

S3200 CNC controller module — rear panel components

S3200 SAS controller module — rear panel components

S2200 SAS controller module — rear panel components

E1024/E1012 drive enclosure rear panel components

CompactFlash

Installing the enclosures

Connecting the controller enclosure and drive enclosures

Connecting the S3200/S2200 controller to the 2U12 drive enclosure

Summary of cabling connections for S3200/S2200 enclosures

Summary of drive enclosure cabling illustrations

Fault-tolerant cabling between a dual-controller enclosure and three 2U drive enclosures

Fault-tolerant cabling between a dual-controller enclosure and seven 2U drive enclosures

Testing enclosure connections

AC power cord

Connecting hosts

Fibre Channel protocol

HD mini-SAS technology

HD mini-SAS host connection

Connecting hosts: S3200 direct attach—one server/one HBA/single path

Dual-controller configurations

Connecting hosts: S3200 direct attach—two servers/one HBA per server/dual path

Connecting hosts: S2200 direct attach—four servers/one HBA per server/dual path (fan-out)

Connecting switch attach configurations

Connecting hosts: S3200 switch attach—four servers/multiple switches/SAN fabric

Connecting a management host on the network

Obtaining IP values

Connecting a USB cable to the CLI port

Change the CNC port mode

Basic operation

Troubleshooting

Monitor event notification

Isolate the fault

Diagnostic steps

Is the controller back panel CRU OK LED off

Is a connected host port Host Link Status LED on

Is the power supply Input Power Source LED off

Isolating a host-side connection fault

Sensor locations

Power supply module voltage sensors

A LED descriptions

Enclosure bezel removal

drive enclosure front panel LEDs

Disk drive LEDs

LEDs: Disks in SFF and LFF enclosures

Controller enclosure — rear panel layout

S3200 CNC controller module — rear panel LEDs

LEDs: S3200 CNC controller module (1 Gb RJ-45 SFPs)

S3200 SAS controller module—rear panel LEDs

S2200 CNC controller module — rear panel LEDs

LEDs: S2200 CNC controller module (1 Gb RJ-45 SFPs)

S2200 SAS controller module—rear panel LEDs

Cache Status LED details

E1024/E1012 drive enclosure rear panel LEDs

B Specifications and requirements

Electrical guidelines

Physical requirements

Environmental requirements

Electrical requirements

C Electrostatic discharge

D USB device connection

Supported host applications

Setting parameters for the device driver

E SFP option for CNC ports

Verify component operation

F SAS fan-out cable option

HD mini-SAS to HD mini-SAS fan-out cable

Index

S3200

key features

system specifications

controller enclosures

raid controller modules

system upgrades

expansion enclosures

physical specifications

operating environment

regulatory compliance

power distribution units

technical specifications

drive options

Lenovo S3200 Quick Start Manual

Product

Learn More

Legal


Contents solution overview bill of materials	Lenovo Storage S3200 withFibre ChannelQuick Start GuideBryan ReeseDavid VestalJeff LinJuly 2016©2016 Lenovo. All rights reserved. Next / 22