OneStart

Menu
Lenovo RackSwitch G7000 Installation Manual Manual pdf 22 page image

Lenovo RackSwitch G7000 Installation Manual

Page 1 previewPage 2 previewPage 3 previewPage 4 previewPage 5 previewPage 6 previewPage 7 previewPage 8 previewPage 9 previewPage 10 previewPage 11 previewPage 12 previewPage 13 previewPage 14 previewPage 15 previewPage 16 previewPage 17 previewPage 18 previewPage 19 previewPage 20 previewPage 21 previewPage 22 previewPage 23 previewPage 24 previewPage 25 previewPage 26 previewPage 27 previewPage 28 previewPage 29 previewPage 30 previewPage 31 previewPage 32 previewPage 33 previewPage 34 previewPage 35 previewPage 36 previewPage 37 previewPage 38 previewPage 39 previewPage 40 previewPage 41 previewPage 42 preview
Contents
  1. Table Of Contents
  2. Chapter 1. Introduction
  3. major components
  4. hardware options
  5. technical specifications
  6. required tools
  7. environmental requirements
  8. Handling static-sensitive devices
  9. Installing and removing the redundant power supply in a standard equipment rack
  10. Installing the redundant power supply
  11. Removing the redundant power supply from a standard equipment rack
  12. Installing and removing the redundant power supply in a Lenovo System x or IBM Power rack
  14. Removing the redundant power supply
  15. before you call
  16. using the documentation
  17. Appendix B. Notices
  18. important notes
  19. electronic emission notices
  20. Industry Canada Class A emission compliance statement
  21. Japan VCCI Class A statement
  22. Korea Communications Commission (KCC statement
  23. Taiwan BSMI RoHS declaration
  24. Index
Lenovo RackSwitch G7000 Installation Manual Manual pdf 22 page image
Installing the redundant power supplyTo install the redundant power supply in a Lenovo System x or IBM Power rack, complete the followingsteps:1. Locate and record the product information to configure and register your product and set aside. SeeBefore installing the redundant power supply.2. Remove the rear cover screws.3. Use the M4 screws to attach the front mounting brackets to each side of the redundant power supply.Torque the screws to approximately 1.13 Nm (10 inch-pounds).71994. Use the M6 screws, washers, and clip nuts to connect the front mounting brackets to the front and rearposts in the rack. Torque the screws to approximately 3.5 Nm (30 inch-pounds).14 Lenovo RackSwitch G7000 Redundant Power Supply Installation Guide
/ 42
Related manuals for Lenovo RackSwitch G7000
Lenovo ThinkSystem SR650 Quick Start Manual first page preview
Lenovo ThinkSystem SR650 Quick Start Manual
This manual is suitable for:
RackSwitch G7000
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved