Lenovo L1210E Replacement Manual

Contents

replacing the lamp

Replacing the LampAllow the projector to cool for at least 60 minutes.Turn off the projector and unplug the power cord.Gently press the lamp into place. Then tightenthe screw. Gently press the yellow tab inward until it stops.You can feel the lamp connector engage.Slide the front grill toward the lens until it snaps intoplace. To reset the lamp timer, press and hold thereset button, then press the menu/select button(while still pressing the reset button) for 10 seconds.!9 *009-0563-04*Place the projector rightside up on a flatsurface. Pull the yellow tab on the lamp outward.This disengages the lamp connector.Place the projector on its side. Slide the lamp intothe projector. Make sure that the bottom of the lampfits into the rails inside the projector (circled above).Loosen the captive screw on the lamp.Place the projector on its side. Grasp the pull tab topull the lamp out. Dispose of the lamp module inan environmentally proper manner.Place the projector on its rear. Insert a small screw-driverinto the slot near the front. Slide the latch downward. Holdthe latch open while you slide the lamp grill off.Pull tab outThe projectormust beas shown.Slide and hold latchSlide lamp grill offSlide lamp grill on

/ 1

Related manuals for Lenovo L1210E