E-1FEDERAL COMMUNICATIONSCOMMISSION (FCC) WARNINGInstruction to UsersThis equipment has been tested and found to complywith the limits for a Class B digital device, pursuantto part 15 of the FCC rules. These limits are designedto provide reasonable protection against harmful in-terference in a residential installation. This equipmentgenerates, uses and can radiate radio frequency energyand, if not installed and used in accordance with theinstructions, may cause harmful interference to radiocommunications. However, there is no guarantee thatinterference will not occur in a particular installation.If this equipment does cause harmful interference toradio and television reception, which can bedetermined by turning the equipment off and on, theuser is encouraged to try to correct the interferenceby one or more of the following measures.- Reorient or relocate the receiving antenna.- Increase the separation between the equipmentand the receiver.- Connect the equipment into an outlet on a cir-cuit different from that to which the receiver isconnected.- Consult the dealer or an experienced radio/ TVtechnician for help.This equipment has been certified to comply with thelimits for a Class B computing device, pursuant topart 15 of the FCC rules. Only peripherals (computerinput / output devices, terminals, printers etc.) certifiedto comply to the Class B limits may be attached tothis computer. Operation with non-certifiedperipherals is likely to result in interference to radioand TV reception.RemarksTo meet FCC requirement, shielded cables are requiredto connect the device to a personal computer or otherClass B certified device.Information to UsersAny change or modifications expressly approved bythe party responsible for compliance could void theuser's authority to operate this equipment.DOC NOTICEThis product conforms to Canadian Class B emissionsregulations.Ce produit est conforme aux réglements d’émissionCanadienne class B.TCO95 NOTICEThis product is delivered with a shielded cord set. Inorder to comply with TCOs requirements for lowelectromagnetic emission this cord set must be used,connected to a grounded outlet. If the cord set isreplaced by another cord set we can not guarantee thatthe product still complies with TCOs requirements.