Lenovo 098118U Installation And User Manual

Also see for ThinkServer TS200v 1008: Hardware Maintenance Manual

Contents

6. Slide the new optical drive into the optical drive bay from the front of theserver until the optical drive snaps into position.7. Reinstall the front bezel. See “Removing and reinstalling the front bezel” onpage 19.8. Continue at “Connecting a SATA drive.”What to do next:v To work with another piece of hardware, go to the appropriate section.v To complete the installation or replacement, go to “Completing the partsreplacement” on page 44.Connecting a SATA driveYou can connect a SATA optical drive or a SATA hard disk drive to an availableSATA connector on the system board.To connect a SATA drive, do the following:1. Connect one end of the signal cable to the SATA drive and the other end to anavailable SATA connector on the system board. See “System-board internalconnectors” on page 14.Figure 16. Installing the optical driveChapter 5. Installing or replacing customer replaceable units 27