22OPERATIONIntended UseThis cordless pole saw is designated with rated voltage of 40 V . It is designed only to be used withthe battery packs 40LB4001.The product is intended for cutting and pruning limbs up to a maximum thickness of 6" / 150mm. Itmust not be used for cutting other materials, such as plastic, stone, metal or wood that containsforeign objects, or materials that are harmful to health.The product may only be used with the guide bar/chain combination stated within these instructions.The use of other types or sizes is not allowed. For safety reasons it is essential to read the entireinstruction manual before first operation and to observe all the instructions therein.This product is intended for private domestic use only, not for any commercial trade use. It must notbe used for any purposes other than those described.Cutting Head Pivot Adjustment (Fig. 27)Adjust the angle of the cutting head (12) to fit the operationconditions.● Press the pivot button (16) and hold it in position(Fig. 27, step 1).● Move the cutting head slightly up or downward.● Release the pivot button (16) and keep moving the cuttinghead until it locks in place (Fig. 27, step 2).12162.1.Fig. 27452.1.Fig. 28Switching ON / OFF (Fig. 28)● Ensure the chain (25) and guide bar (21) do not comeinto contact with anything before starting the product.● Press the lock-off button (5) (either from left or right side)and hold it in position (Fig. 28, step 1).● Press the on/off switch (4) to switch the product on(Fig. 28, step 2). The lockoff button (5) can then bereleased.● Release the on/off switch (4) to switch the product off.Chain Stop TestThe product must always be held with two hands when switching it on.● Hold the front handle with the left hand, the rear handle with your right hand.● When switching on, the guide bar and the chain must not be in contact with any object.● Release the on/off switch to switch the product off. The chain must come to a stop.