Larson Electronics Golight RadioRay GL-7 GT Series Instruction Manual

Larson Electronics Golight RadioRay GL-7 GT Series Instruction Manual Manual pdf 1 page image

GL-7XXXGT SeriesLarson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 1 of 4Golight RadioRay GL-7XXXGT SeriesInstruction ManualCongratulationsYou are now the owner of one of the finest remote control searchlights available today. Thank you for letting LarsonElectronics assist you in your lighting application needs. We’re proud of our products and the technology that we’vedeveloped to ensure our customers the most durable, versatile and power-ful searchlights in the lighting industry.Please read these instructions before using your new Golight® Radioray.The Golight RadioRay GL-7XXXGT Series portable spotlights aredesigned to be attached to a vehicle using a magnetic or permanentmount shoe and operated by a wireless remote control. Each spotlighthas 370° horizontal rotation and 135° vertical tilt.The RadioRay GT Includes:• RadioRay Portable Spotlight• Wireless Handheld Remote with two A23 12V Batteries• Magnetic Mount ShoeORPermanent Mount Shoe• Rockguard (If Applicable)MOUNTING INSTRUCTIONS - SPOTLIGHTMagnetic Mount Shoe1. Select the best location for mounting the magnetic shoe. Make sure the metal area under the magnetic shoe isflat and clean to ensure a strong bond.2. Aluminum vehicles will require a magnetic base. Visit our web store at https://www.larsonelectronics.com/Permanent Mount Shoe1. Determine the location for the light on your vehicle. This should be aflat surface. The small arrow on the base indicates the normalforward direction of the light. The light will rotate to the left of thisarrow 185 degrees and to the right 185 degrees. The lamp will tiltdown 45 degrees and tilt up 90 degrees. The location should take intoconsideration this range of motion to maximize usability. Keep inmind the swing diameter is 261.4 mm (10.3 inches) from the center ofthe permanent mount shoe – see Figure 1. This allows for clearanceas the light is rotating.2. The permanent mount shoe is designed to be mounted with eithersheet metal screws or a combination of cap screws, nuts andwashers. You should choose hardware appropriate to the surface towhich you intend to attach the light. Drill holes in mounting surface foreither type of hardware depending upon your preference. Refer toFigure 1 for hole pattern dimensions.3. Place the black mounting gasket under the mounting shoe and attachthe shoe and gasket to vehicle using preferred hard-ware. Silicone orother like sealants should not be used around the mounting gasket asit will limit the ability to drain water properly.Figure 1 – Permanent Mount Shoe/Spotlight – Bottom ViewLooking Up - Dimensions in mmFigure 1

/ 4

Related manuals for Larson Electronics Golight RadioRay GL-7 GT Series