Larson Electronics GL-52893 Instruction Manual

Larson Electronics GL-52893 Instruction Manual Manual pdf 1 page image

GL-52893Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 1 of 2HID Golight Stryker - 35 Watt HID - 3000 Lumen - 2 WirelessRemotes - White - 12 Volt - GL-52893Instruction GuideThe GL-52893 Golight Stryker is designed for use in all weather conditions andproduces 3000 lumens of intense light output. These units feature remotecontrol operation that allows users to rotate the light 370 degrees with a hard stop and toadjust vertical tilt through 135 degrees. Remote operation is provided by a wirelesshand held remote control. The hand held remote measures 3 inches long by 2 incheswide by 3/8 inch thick.MOUNTING INSTRUCTIONSThis light mounts using a detachable design with a separate permanent mount interlocking stainless steelmounting plate that is affixed to the mounting surface. The mounting plate is attached with 3 screws throughpredrilled holes which secure the plate to the mounting surface. The Golight Stryker attaches to the mountingplate via an interlocking base bracket and a single machine screw which secures the Golight to the mountingplate.Note: Once power is applied to the system the light will pan and tilt prior to illumination. Eachspotlight needs to be wired on a single dedicated circuit and the power fused at 5 amps. With the powerconnected, your light is ready for operation.POWER SUPPLYOn this particular model, the light ends in a 1 foot pigtail with stripped and tinned leads. The operator isresponsible for providing the wiring from the battery and/or fuse box to the light. 16 AWG is recommended.OPERATION OF SPOTLIGHT1. Using the remote control, turn on the light by depressing the on/ off button.2. With the arrows on the wireless control, rotate your light to the desired location.3. The speed of the light rotation can be controlled by depressing the fast/slow button one time and bydepressing it again to restore the original speed.BATTERY INSTALLATION AND REMOVAL FOR TRANSMITTER Remove battery cover: forwireless hand-held transmitter, remove phillips head screw to remove cover. With batterycompartment now exposed, insert GP 23A 12V batteries according to the correct polarity or gently removebatteries by grabbing the positive end and lifting up.PROGRAMMABLE REMOTE INSTRUCTIONSThe Light is controlled with a programmable remote with 2187 different channels. This feature allowsyou the freedom to change the channel selection, and the receiver re-learns the new selection. Thislight has been pre-programmed at the factory, and it is not necessary to re-program the transmitter, unlessyou experience outside interference.To program transmitter:1. IMPORTANT Disconnect power.2. Remove battery cover from remote control.3. Set the 7 dip switches to a selection of your choice. There are 3 positions on each; positive,negative and neutral. Use a small screwdriver and select a position for each dip switch.*Please note that the orientation of the +/- switch positions may vary among different modelsof wireless remote controls.4. Insert both GP 23A 12V batteries. Be sure batteries have adequate charge.

/ 2

Related manuals for Larson Electronics GL-52893