Shore Ramp PWC-50 p/n: 000004 rev A 1 doc: 400005 copyright© 2018 Lakeside Recreation, LLCShore Ramp PWC-50 (M4)Assembly & Use Instructionsp/n: 000004Lakeside Recreation LLCwww.lakesiderecreation.comIMPORTANT NOTE ABOUT STAINLESS FASTENERSStainless fasteners may gall and seize up (cold weld) if assembled without lubrication. Be sure to apply a dab of thesupplied anti-seize compound to the threads of each stainless bolt prior to assembling the nut.Assembly1. Unpack the box and confirm that all the parts are present according to the parts list.2. Lay the Keel Beam and Front Beam on a flat surface end to end, with the bottom access openings facing up. Assemblethem together using the 2 Connector Plates, and 16 sets of 1.00” 3/8-16 bolts, washers, and nuts. Get all the boltsinserted and the nuts started before tightening any of them. Tighten all 16 sets of fasteners firmly.

Lakeside PWC-50 M4 Assembly & Use Instructions

Product

Learn More

Legal