Laguna Tools MTST5S-0135 Operating Manual

Contents

Laguna Tools MTST5S-0135 Operating Manual Manual pdf 15 page image

3. ASSEMBLY & SETUP133-5 FITTING OR CHANGE SAW BLADE & RIVING KNIFEI. SAW BLADE FITTINGThis machine is designed to accommodate the saw blade with the size up to 305mm,but every time you change blade, the blade appropriate size of riving knife must alsoto be changed to match the size you installed.Note: please wear gloves during installation or replacing of saw blades.1. Disconnect the power source.NOTE: Serious personal injury could occur if you connect your machine to thepower source before you change blade.2. Move the blade tilt to 0r and raise the saw blade as high as it can be adjusted.3. Push the saw guard up and loosen the fixed bolts of insert. Take off the insertplate.(Fig.3-5.1 & 3-5.2)4. Open the red cover, R (Fig. 3-5.2a).Note: the red cover is used as a guard for protecting operators from injured bythe bladesFigure 3-5.1Figure 3-5.2 Figure 3-5.2a R