MOTOR PUMPWATER PURIFIERE n g l i s h14Start by setting the main switch (part 1) to the “0” posi-tion.Disconnecting from the power outletIn case the machine is connected through the plug (part24), make sure that the switch (part 23) is also in the Offposition before disconnecting. Disconnect the motorpump (part 15) by pulling out its special plug (part 25).Disconnecting from the water systemShut off the water supply by closing the specific taplocated upstream of the purifier inlet. Disconnect thewater pipe at the purifier (part 17) inlet, which is locat-ed just downstream of the special tap (part 18), whichhas been closed in advance.Proceed to remove the drain well piping (part 19, Fig.1).At this point, the machine may be removed from thebar, being very careful not to drop it or squash your fin-gers.The machine is made out of various materials and there-fore, if you do not intend to put it back in service, it mustbe taken to a special disposal company which will selectthe materials which can be recycled and discard the oth-ers.Current regulations make it illegal to discard suchmachine by leaving it on public grounds or on any pri-vate property.7. De-commissioning and demolitionfig. 3 (see also pag. 7)