KitchenAid Undercounter Dishwasher 8573157 Installation Instructions Manual

Contents

KitchenAid Undercounter Dishwasher 8573157 Installation Instructions Manual Manual pdf 14 page image

14Option 2: Power supply cord method1. Plug into a grounded 3 prong outlet.2. Check that power supply cord does not touchdishwasher motor or lower part of dishwasher tub.Connect to water supplyHelpful Tip:Compression fittings:a. Slide nut onto copper tubing about 1" (2.5 cm).b. Slide ferrule onto the tubing. Do not position ferruleon the end of the tubing.c. Put the tubing into the elbow as far as it will go.d. Slide the nut and ferrule forward and start the nutonto the elbow threads. Be gentle when handlingand positioning the copper tubing, it bends and kinkseasily.1. To prevent vibration during operation, route the watersupply line so that it does not touch the dishwasherbase, frame or motor.2. With copper tubing pushed into compression fitting asfar as it will go, use a wrench and tighten compressionfitting nut to elbow on water inlet valve.3. Place paper towel under elbow. Turn on water supplyand check for leaks.nutferruleelbowElectrical Shock HazardPlug into a grounded 3 prong outlet.Do not remove ground prong.Do not use an adapter.Do not use an extension cord.Failure to follow these instructions can result in death,fire, or electrical shock.WARNING4. Form bare ground wire into a U-shaped hook. Wrapground wire hook clockwise around ground connectorand under the washer.5. Securely tighten ground connector.6. Tighten clamp connector or conduit connector screws.7. Reinstall terminal box cover with wires inside terminalbox.The cover must be outside the box on the left side.8. Make sure no wires are pinched by cover.screwsADVERTENCIAAVERTISSEMENTWARNINGElectrical Shock HazardElectrically ground dishwasher.Connect ground wire to green ground connector interminal box.Do not use an extension cord.Failure to follow these instructions can result in death,fire, or electrical shock.ground wire washergroundconnectorground wire