KitchenAid Undercounter Dishwasher 8573157 Installation Instructions Manual

Contents

KitchenAid Undercounter Dishwasher 8573157 Installation Instructions Manual Manual pdf 11 page image

11NOTE: Features on yourdishwasher may differfrom model shown.For top vented modelswith a factory-suppliedstainless or painted fullfront panel:1. Remove the carton containing the factory-supplied fullfront panel.2. Remove the handle package from the front of theshipping base.3. Remove the inner panel from the door.4. With a TORX ® screwdriver, remove three screws fromboth sides of the door. Hold the inner panel up whileremoving the screws. align top edges2 screws10. Install the two #8-18 x 1-3/8" screws from the literaturepackage in the top corners of the door.11. Align the top edge of the full front panel with the topedge of the console and secure corner screws.12. Tighten the two screws installed in Step 9.13. Reinstall and tighten the remaining screws in the innerpanel.5. Gently set panel aside.NOTE: Some models have 4 screws per side.6. Lay the factory-supplied full front panel face down on aprotective non-scratching surface.7. Place the inner panel on the back of the full front panelas shown and attach, using the four #10-16 x 3/8" screwsin the literature package.8. Attach the factory-supplied full front panel, inner panel,and handle assembly to the door.9. Reinstall the two uppermost screws into the inner panel,do not tighten completely. This will hold the full frontpanel in place on the door frame.top of panelInstall the door handle (on some models)IMPORTANT: Do not scratch the front panel during thisprocedure.1. Remove the door handle and hardware bag containingthe setscrews and Allen wrench from the cardboard box.2. Start set screws in handle.3. Place handle on mounting studs with the set screwsfacing down.4. Push the door handle tightly against the door. Insert theshort end of the Allen wrench into the setscrews.Tighten the setscrews 1/4 turn past snug. Retain Allenwrench with Installation Instructions. do not remove screw.screws4 screwsfull front panelinner door panel2 screwsscrewsinnerdoorpanel1. Remove the Pro Line ® Series handle and two screwsfrom handle package.2. Make sure plastic spacers are still attached to the door.3. Attach the handle to the factory-supplied full front panelas shown.Pro Line® Seriesplastic spacersInstall door panel (Pro Line ® series)top ventAllenwrenchsetscrew(in bottomof handle)handlemountingstud