Drawer DishwasherPRODUCT MODEL NUMBERS PRODUCT DIMENSIONSCUTOUT DIMENSIONSKUDH03DTElectrical: 120-volt, 60-Hz, AC-only, 15- or 20-amp fused electricalsupply. Use copper wire only. A time-delay fuse or circuit breaker andseparate circuit is recommended.Water: A hot water line with 20 to 120 psi (138 to 862 kPa) waterpressure. Water temperature must be 120°F (49°C) at dishwasher. Useflexible stainless steel braided fill line (1/2" [1.3 cm] minimum plastictubing not recommended).Drain Requirements: Use the new drain hose supplied with yourdishwasher. If this is not long enough, use a new drain hose withmaximum length of 12 ft (3.7 m) that meets all current AHAM/IAPMOtest standards, is resistant to heat and detergent, and fits the 1" (2.5 cm)drain connector of the dishwasher.Connect drain hose to waste tee or disposer inlet above drain trap inhouse plumbing and 20" (50.8 cm) minimum above the floor. It isrecommended that the drain hose either be looped up and securelyfastened to the underside of the counter, or be connected to an air gap.Use a drain air gap if the drain hose is connected to house plumbinglower than 20" (50.8 cm) above the subfloor or floor.Use 1/2" (1.3 cm) minimum I.D. drain line fittings.Because Whirlpool Corporation policy includes a continuous commitment to improveour products, we reserve the right to change materials and specifications without notice.Dimensions are for planning purposes only. For complete details, see InstallationInstructions packed with product. Specifications subject to change without notice.Ref. W1018504208-27-08®23³⁄₈"(59.4 cm)19¹⁄₄"(48.9 cm)1¹⁄₂"(3.8 cm)24"(61 cm)33³⁄₄"(85.7 cm)23¹⁄₂"24"(61 cm) 33³⁄₄"(85.7 cm)(59.7 cm)NOTE: All holes should be drilled at 1½" (3.8 cm) diameter.A. Choose left-hand or right-hand drain and water connection route.B. Choose left-hand or right-hand electric connection route.AB25"(63.5 cm)1/2"(1.3 cm)8"(20.3 cm)PREFERRED UTILITY AREA