Electrical Shock HazardPlug into a grounded 3 prong outlet.Do not remove ground prong.Do not use an adapter.Do not use an extension cord.Failure to follow these instructions can result in death,fire, or electrical shock.Plug into a grounded 3 prong outlet. Check that power supplycord does not touch dishwasher motor or lower part ofdishwasher tub.Reconnect Power• Read the Dishwasher User Instructions that came with yourdishwasher.Check that all parts have been installed and no steps wereskipped. Check that you have all tools used.Start dishwasher and allow it to complete the shortest washcycle. After the first 2 minutes, unlatch door, wait 5 seconds,then open door. Check that there is water in the bottom of thedishwasher tub. Check that dishwasher is working properly.If the dishwasher is not working properly, disconnect power orunplug dishwasher and see "If Dishwasher Does Not Operate"section..... _<', _ !..................... _,,,II;=_;:11!_QFirst try the solutions suggested here to possibly avoid the cost ofa service call.• Has the circuit breaker tripped or the house fuse blown?• Is the door closed tightly and latched?• Has the cycle been set correctly to start the dishwasher?• Is the water turned on?If none of these possible solutions work, call 1-800-422-1230, orin Canada, call 1-800-807-6777.Expect longer wash times. Your new dishwasher will average2-3 hours per load, but use nearly 40% less energy than oldermodels. Designed with a low wattage, low energy consumptionmotor, your dishwasher washes longer to ensure exceptionalcleaning. Certain models are equipped with an optical watersensor so the first cycle will run longer to calibrate to opticalsensor. Selecting certain options could increase cycle time past3.5 hours.Rinse Aid is necessary for good drying results:This dishwasher is designed to be used with rinse aid for gooddrying performance and controlling hard water deposit buildup.Energy efficient dishwashers use less water and energy, so theydepend on the water sheeting action of rinse aid for good dryingperformance.Start/Resume light may flash:When pressing Start/Resume, you must make sure the door isclosed within 3 seconds. If you do not close the door within3 seconds, the Start/Resume light will flash until you press itagain. (You must also do this when adding a dish during themiddle of a cycle.)NOTE: If a braided supply hose is used, replace inlet hose after5 years to reduce the risk of hose failure. Record hose installationor replacement dates on the hose for future reference.26