KitchenAid KUDC20CVBL - Kitchen-Aid Dishwasher Installation Instructions Manual

Also see for KUDC10FXWH: Energy guide User instructions Installation instructions

KitchenAid KUDC20CVBL - Kitchen-Aid Dishwasher Installation Instructions Manual Manual pdf 22 page image

22Connect to DrainPlace towel under drain hose to catch any water in drain hose.Place the small green drain hose clamp onto the small end of thedrain hose. Push the new drain hose into the black drain hoseconnector up to the drain hose stop.Using pliers, squeeze open the small green drain hose clamp andslide onto connector between stops.After hose is connected, remove towel.If needed, see website for animated representation of this step.Visit www.kitchenaid.com/drain under FAQ tab.Make Direct Wire ElectricalNOTE: If the power supply cord was connected earlier, proceed to“Secure Dishwasher in Cabinet Opening” section.Option B, Direct Wire:Route cable so that it does not touch dishwasher motor or lowerpart of dishwasher tub. Pull cable through UL Listed/CSAApproved strain relief in terminal box. Strain relief is not suppliedwith the dishwasher. Owner must purchase a ⁷⁄₈" screw-in typestrain relief.Select UL Listed/CSA Approved twist-on wire connectors (notincluded) rated to connect your household wiring to 16-gaugedishwasher wiring.