Kinki Studio EX-M1 Instruction Manual

Contents

Kinki Studio EX-M1 Instruction Manual Manual pdf 8 page image

5. ControlPower UpThe power inlet IEC of the EX-M1 is located at the rear panel. After the power is supplied to theamplifier, it will be in Standby state.Press the front panel left knob (SELECT) once. The display indicator light flashes signify a Start Upsequence. The input signal source (CH1-4) and volume display appear once the amplifier is startedin Operational state.Under normal working conditions, press and hold the left button (SELECT) on the front panel forfive seconds, then release it, the amplifier will go into Standy. The indicator in the lower rightcorner lights up.Note: Whenever you turn it on, the volume will be automatically set to 10 position to avoiddamage to the speaker caused by excessive volume.Volume adjustmentRotate the front panel right knob (VOLUME) to adjust the volume, to reduce volume, turn left; toincrease volume, turn right. Each step is 0.5db, there are total 256 steps.KINKI STUDIO04