Menu
Kingwave KW5229 User Manual
  | |
Contents | 
1.Contents:1. One Camera2. One 3dBi Antenna3. One User Manual2.Channel SelectionEach camera must be placed on a separate 5.8GHz wireless channel byselecting the proper DIP switch configuration outlined in the table below. Forbest results place wireless cameras on every other channel. For example,for a typical wireless camera setup place camera one on channel 1, cameratwo on channel 3, camera three on channel 5, and so on. You can utilize upto 7 channels.There is a 4 lever DIP switch located inside the wireless camera. Pleaseunscrew the two screws located on the top of the camera casing and removethe camera sun shield. To open the camera housing remove the two screwson the left side of the camera casing that provide a weather proof seal.Please be sure to properly tighten these cameras when reassembling thecamera after you are done.Open the camera casing and locate the DIP switch seated behind the boardcamera module and set the camera to one of the 7 available wirelesschannels based on the DIP switch configuration listed in the table below.Please configure the wireless receiver to the same wireless channel bysetting the same DIP switch settings as the camera you configured above.Notice : The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antennaor the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate the device. |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved