Kinco FV100-2S-0004G User Manual

Also see for FV100 Series: User manual User manual

Contents

Kinco FV100-2S-0004G User Manual Manual pdf 70 page image

6767In Fig.6-46, a1~a15 and d1~d15 are the acceleration anddeceleration of the steps.f1~f15 and T1~T15 are thesetting frequency and operating time of the steps.Thereparameters are defined in group C2.PLC step finish signal and PLC cycle finish signal canbe output with pulse signal which last 500ms bybi-direction open collector output Y1, open collectoroutput Y2 or relay. Set function code as 12 and 13 forparameters A6.14, A6.16 or A6.25.C2.00 Simple PLC operationmode selector 0~1123H【0000】A B C D0: No function1: Stop after single cycle2: Keep final states after single cycle3: Continuous cycle0: Start from first step1: Start from the step before stop(or alarm).2:before stop(or alarm)Start from the step and frequencyStorage after power off0: Disable1: Save the segment,frequency whenpower offTime unit selector for each step0: Second1: MinuteStart modeThe unit’s place of LED: PLC function running mode0: No function.Simple PLC function is invalid.1: Stop after single cycle.As shown in Fig.6-47, the drive will stop automaticallyafter finishing one cycle running,the wait for anotherstart signal to startup.Fig.6-47 Stop after single cycle2. Keep final states after single cycleAs shown in Fig.6-48, the drive will keep running at thefrequency and direction in last step after finishing singlecycle.Fig.6-48 Keep final states after single cycle3. Continuous cycleAs shown in Fig.6-49, the drive will continue next cycleafter finishing one cycle, and stop when there is stopcommand.Fig.6-49 Continuous cycle