Kimo CP 111 Technical Data Sheet

Contents

Kimo CP 111 Technical Data Sheet Manual pdf 2 page image

TECHNICAL SPECIFICATIONSCONNECTIONSLeft DIPswitchPressure connectionsOutput / Supply - active sensor 0-10 V or 4-20 mA (alim. 24 Vac/Vdc ± 10%), 3-4 wires- passive loop 4-20 mA (power supply 16/30 Vdc), 2 wires- maximum load : 500 Ohms (4-20 mA)- minimum load : 1 K Ohms (0-10 V)Consumption 2 VA (0-10 V) or max. 22 mA (4-20 mA)Electromagnetical compatibility EN61326Electrical connection Screw terminal block for cables from 0.05 to 2.5 mm2 or from 30 to 14 AWGCommunication to PC USB-mini DIN cableEnvironment Air and neutral gasesInside the front housingELECTRICAL CONNECTIONS – as per NFC15-100 standardThis connection must be made by a qualified technician. To make the connection, the transmitter must not be energized.For CP111/112/113 – AO models and CP111/112/113 – ANmodels with 0-10 V or 4-20 mA output – active, 4 wires :A- +76 LNPower supply24 Vacclass IIorN L1 2+3VP+5IP4GND-7+6-Power supply24 Vdc-VRegulator display orPLC/BMSpassive typeor-+4wiresTo make a 3-wire connection, before powering up thetransmitter, please connect the output ground to theinput ground. See drawing below.4 wires 3 wiresSolenoid valve(only CP111)+Regulator display orPLC/BMS passive type-1 2+3VP +5IP4GND-7+6-3 wiresPower supply24 Vdc+5IP4GND-7L6N+Power supply24 Vacclass IILNA- +orVRegulator display orPLC/BMS passive type-+Regulator display or PLC/BMSpassive typeOutput terminalblockPower supply terminalblockLCC-SconnectionFixed back housingRemovable front faceCable glandAutozeroRight DIPswitchor

/ 4

Related manuals for Kimo CP 111