Menu
KidKusion KIDSAFE BANISTER GUARD Instructions Manual
  |
This product is not a substitute for adult supervision.Questions - Please call 1-800-845-9236 or vist www.kidkusion.comKidKusion is a registered trademark of KidKusion Inc.C 2011 KidKusion Inc. All Rights ReservedMade in the USADistributed by KidKusion Inc.KIDSAFE BANISTER GUARD INSTRUCTIONSCLEAR BANISTER GUARDThe KIDSAFE BANISTER GUARD is a roll of clear, durable plastic film that you cut to fit your banister.The KIDSAFE BANISTER GUARD is then fastened to the banister with cable ties. Plastic, cable ties,and hole punch are provided. You will need a tape measure, straight edge, marker, and scissors.1. Measure the length and the height of the section of banister to be covered. Add at least 2 inches foroverlapping at both ends. If one end lacks a post, add 6 inches so that guard may be curled into wall.(See diagram on reverse side of instructions).2. Unroll plastic onto floor. Using a marker and straight edge, draw a line as a cutting guide for lengthneeded and using scissors cut plastic. If height requirement is less than 33 inches, mark the measurementon the plastic in several places and draw a line using a straight edge and marker. Cut plastic along line.3. Hold plastic in place with ends overlapping endpost (overlap by 2 inches) and/or wall (overlap by6 inches). Make a mark on the plastic on either side of one of the banister posts no less than ½ inch fromthe top edge (See reverse side of instructions). Use hole punch to punch hole at your marks. Press hard,you may need to use both hands. If you should need to punch holes more than 1 inch from the edge ofplastic, you may use a sharp object such as an ice pick. Be careful and always punch holes from the side ofplastic that will be exposed to the child. For best results, you can use a drill with 1/8 inch bit. Use onecable tie and insert through the holes from the backside of the plastic and into the locking ends of cable tie,so that locking end is on the back side of plastic. Tighten the tie, cut off excess.4. Hold plastic in place so that it is level and resting flat against the banister. Mark two holes no less than ½inch from bottom edge on either side of the same post. Punch the holes. Place a tie through the holes withthe locking end on the inside. Tighten the tie and cut off excess squarely. Repeat this process along thebanister at every other post (see diagram on reverse side of instructions).5. KIDSAFE BANISTER GUARD may be fastened to endpost with cable ties. For more secure attachment toendpost, drill a 3/16 inch hole through the plastic and into the endpost, then secure plastic with screwsand washer provided. Space screws or ties no more than 10 inches apart.If end of railing does not have a post, curl the plastic against the wall and drill 3/16 inch holes through theplastic and into the wall at 6”-10” intervals (See diagram on reverse side of instructions). Place a plastic anchorinto each hole in the wall, then attach plastic with screws and washers.Important: With guard installed, recheck all ties to be sure they are tight. Usescissors to round off all corners of the guard to remove sharp edges.FOR INDOOR USE ONLYThis product is not a toy. Do not allowchildren to play with it.www.kidkusion.com1-800-845-9236R“Because Kids Will Be Kids!”Model 4600 |
Related manuals for KidKusion 4600
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved