2SPECIFICATIONSWIRINGSolo-Baric L3 subwoofers are available with dual 2 (ohm) or dual 4 voice coils. Both coils must beconnected to a source of amplification. The dual 2 woofer will generate a 1 load if the coils are wiredin parallel or a 4 load in series. The dual 4 woofer will provide a 2 load wired in parallel or 8 loadwired in series. The terminals with the white dots are for the first voice coil. The terminals with solid-redand solid-black markings are for the second voice coil. See Figure 1.SOLO-BARIC L3 SUBWOOFEROWNER’S MANUALAuthorized KICKER Dealer:Purchase Date:Subwoofer Model Number:Subwoofer Serial Number:Model S10L3 S12L3 S15L3Nominal Impedance [Zn], ohm 2 or 4 2 or 4 2 or 4Resonance Frequency [fs], Hz 32.85 31.37 24.57Power Handling Watts, Peak (RMS) 800 (400) 800 (400) 1000 (500)Sensitivity [SPLo], dB @ 1W, 1m 85.3 86.3 90.292DC Resistance [Re], ohm 3.9 3.9 3.8Mechanical Q-Factor [Qms] 9.078 9.198 9.881Electrical Q-Factor [Qes] .657 .796 .438Total Q-Factor [Qts] .612 .733 .419Equivalent Volume [Vas], ft³ (L) 1.44 (40.81) 2.5 (71.06) 7.24 (204.94)Outer Frame Diameter, in (cm) 10-11/16 (27.1) 12-5/8 (32) 15-5/8 (39.7)Hole Cut-Out Diameter, in (cm) 9-5/16 (23.7) 11-1/16 (28.1) 13-3/4 (34.9)Mounting Depth, in (cm) 5-1/2 (14) 6-1/4 (15.8) 8-1/8 (20.6)S10L3 / S12L3 / S15L3Models:Note: All specifications and performance figures are subject to change. Please visit www.kicker.com for the mostcurrent information. To get the best performance from your new KICKER Subwoofer, we recommend using genuineKICKER Accessories and Wiring. Please allow two weeks of break-in time for the subwoofer to reach optimumperformance.Sound Check: Poor bass response? Check the system phasing by reversing the positive and negativespeaker connections on the subwoofer. If the bass improves, then the subwoofer was out of phase inreference to the rest of the audio system.