Keysight U1401BHandheld Multi-FunctionCalibrator/MeterQuick StartGuideAll manuals and user guides at all-guides.comall-guides.com

Keysight U1401B Quick Start Manual

safety symbols

Recharging the Batteries

Functions and Features

Protection

Charging the battery

Performing Voltage Measurements

Performing Current Measurements

Continuity Test

Performing Temperature Measurements

Measurements

Square Wave Output

Tilt Stand

U1401B

safety information

Safety Symbols

General Safety Information

Measurement Category

Environmental Conditions

Regulatory Markings

Product category

Getting Started Introducing the U1401B Handheld Multi-Function Calibrator/Meter

Standard Purchase Items

List of Accessories

Figure

Table 1-5 Instructions involving shifted functions

Table 1-6 Description of display annunciators

Table 1-8 Overload protection for the input terminals

The rear panel at a glance

Display selection with the Hz key

Display selection with the DUAL key

Remote Communication

IR-USB cable

Enabling and Disabling the Output

Constant Voltage Operation

Constant Current Operation

Memory Generation

Table 2-1 Default settings for the autoscan output

Selecting autoscan output mode

Autoramp output

Table 2-2 Default settings for the autoramp output

Selecting autoramp output mode

Defining the autoramp output

Parameter selection for square wave output

Making Measurements Measuring Voltage

DC voltage measurement

Measuring AC voltage

Measuring Current

Percentage scale of DC mA measurement

Measuring Temperature

Surface temperature measurement

Measuring Resistance and Testing Continuity

Resistance measurement

Alerts and Warning During Measurement

Math Operations

Dynamic recording mode

Relative (zero)

Triggering Operations

Refresh hold (auto trigger)

m peak hold mode

Entering the Setup Mode

Available Setting Options

Setting the data hold/refresh hold mode

Setting the data hold or refresh hold mode

Setting the temperature unit

Setting the beeper frequency

Setting the minimum measurable frequency

Setting the percentage scale readout

Setting the print mode

Setting the echo mode

Setting the data bit

Setting the parity check

Setting the baud rate

Setting the display backlight timer

Setting the power saving mode

Source Mode for mA Output

Simulation Mode for mA Output

Simulating a 2-wire transmitter on a current loop

Measuring a Pressure Transducer

Zener Diode Test

Diode Test

Bipolar Junction Transistor (BJT) Test

Table 5-2 Base terminal according to probe test

Table 5-4 Polarities and terminals if Pin 2 is the base

Table 5-6 Polarity and terminals if Pin 2 is the base

Junction Field-Effect Transistor (JFET) Switch Test

Table 5-7 Gate terminal according to probe test

Operational Amplifier Verification

Voltage-to-current converter

Integrator: square wave to triangle wave conversion

Wire Transmitter Verification

Frequency Transmitter Verification

Maintenance Maintenance

Battery replacement

Recharging the batteries

Fuse replacement

Table 6-1 Fuse specifications

Keysight U1401B Quick Start Manual

Product

Learn More

Legal