Keysight Technologies 855**A Series User's And Service Manual

Contents

Keysight Technologies 855**A Series User's And Service Manual Manual pdf 19 page image

User’s Guide 85523-90005 1-13855xxA/B Series CalPods and 85523B CalPod Controller Usage InformationStep 5. Connect the LAN CableA LAN cable is required, but is not included. Either a standard or cross-over LANcable can be used. (A cross-over LAN cable is used to connect computing devicestogether directly where they would normally be connected via a network switch,hub, or router.)• The following graphic shows the recommended configuration for the LAN cable. Informationon an alternative configuration can be found at “Alternative Configuration for the LAN Cable(Not Recommended)” on page 2-4. Although this alternative is not recommended, it can beused when the USB 2.0 to LAN adapter is not available.• 85523B CalPod Controllers do not support DHCP networking.• The 85523B CalPod Controller is set to a static IP Address (default: 192.168.0.100.)• For additional information on making connections to the LAN using network switches andnetwork hubs, contact your network administrator.5.1 As shown in the graphic above, connect a LAN cable (not included) to the rear of the 85523BCalPod Controller and connect the other end to the USB 2.0 to LAN adapter (part number0960-2955).5.2 As shown in the graphic above, connect the USB 2.0 to LAN adapter to a USB port on the PNA.(Typically this is on the rear of the PNA, but any USB port can be used.)5.3 Verify that AC line cords are connected to both the PNA and CalPod Controller and that theyare powered on.