Keysight E5061B Configuration Manual

Also see for E5061B: Installation guide Installation guide

Keysight E5061B Configuration Manual Manual pdf 3 page image

Page 3Find us at www.keysight.comStep 3. Choose hardware option (If not required, go to step 4)Option No. DescriptionE5061B-1E5 1 Add High stability time baseE5061B-721 Add GPIB interface (must choose either Option 721 or 722)E5061B-722 Without GPIB interface (must choose either Option 721 or 722)E5061B-731 Add handler I/O interface (must choose either Option 731 or 732)E5061B-732 Without handler I/O Interface (must choose either Option 731 or 732)Step 4. Choose storage option 2Option No. DescriptionE5061B-020 Standard hard disk driveStep 5. Choose software option (If not required, go to step 6)Option No. DescriptionE5061B-010 3 Time domain/fault location analysisE5061B-006 4 Wireless power transfer analysisStep 6. Choose accessory option (If not required, go to step 7)Option No. DescriptionE5061B-810 Add keyboardE5061B-820 Add mouseE5061B-1CM Rack mount KitE5061B-1CN Front Handle KitE5061B-1CP Rack mount and front handle kitStep 7. Choose calibration option (if not required, go to step 8)Option No. DescriptionE5061B-1A7 Calibration + Uncertainties + GuardbandingE5061B-A6J ANSI Z540-1-1994 Calibration1. Refer to “Hardware upgrade” section for retrofit information on the above options.2. Option 020 is the only storage option for the E5061B. Must choose this option when ordering the E5061B.3. Refer to “Software upgrade” section for retrofit information on the above option.4. This option is not applicable for the E5061B 75 ohm test set options 1x7/2x7 and Transmission/Reflection test set options 1x5.