Keysight E5061B Configuration Manual

Also see for E5061B: Installation guide Installation guide

Keysight E5061B Configuration Manual Manual pdf 2 page image

Page 2Find us at www.keysight.comOrdering guideStandard furnished item 1Description Additional informationInstallation guide Contains the information necessary to start up with the E5061B.CD ROM IO librariesPower cableCertificate of calibrationStep 1. Choose test set option (must choose one of the nine test set options.)Option No. Description50 Ω RF NA optionsE5061B-115 Transmission/Reflection test set, 100 kHz to 1.5 GHz, 50 Ω system impedanceE5061B-215 S-parameter test set, 100 kHz to 1.5 GHz, 50 Ω system impedanceE5061B-135 Transmission/Reflection test set, 100 kHz to 3 GHz, 50 Ω system impedanceE5061B-235 S-parameter test set, 100 kHz to 3GHz, 50 Ω system impedance75 Ω RF NA optionsE5061B-117 Transmission/Reflection test set, 100 kHz to 1.5 GHz, 75 Ω system impedanceE5061B-217 S-parameter test set, 100 kHz to 1.5 GHz, 75 Ω system impedanceE5061B-137 Transmission/Reflection test set, 100 kHz to 3 GHz, 75 Ω system impedanceE5061B-237 S-parameter test set, 100 kHz to 3GHz, 75 Ω system impedanceLF-RF NA option 2E5061B-3L3 LF-RF network analyzer with DC bias source, 5 Hz to 500 MHzE5061B-3L4 LF-RF network analyzer with DC bias source, 5 Hz to 1.5 GHzE5061B-3L5 LF-RF network analyzer with DC bias source, 5 Hz to 3 GHzStep 2. Choose impedance analysis option(for E5061B-3L5 LF-RF network analyzer. If not required, go to step 3.)Option No. DescriptionSoftware optionE5061B-005 3, 4 Impedance analysis for E5061B-3L3/3L4/3L5 LF-RF network analyzerAccessoryE5061B-720 4, 5 Add 50 Ω resistor setThe following steps will guide you through configuring your E5061B.1. Keyboard and mouse are not furnished as standard. Refer to “Step 6. accessory option” for the selection of these items.2. The E5061B-3L3/3L4/3L5 includes the 50 ohm S-parameter test set (5 Hz to 500 M/1.5 G/3 GHz), and the gain-phase test port (5 Hz to 30 MHz)3. This option is not applicable for the E5061B RF NA options 1x5/2x5/1x7/2x7.4. Refer to “Upgrade Kit” section for retrofit information on the above option.5. For calibration at test fixtures. Required for the gain-phase series-thru method.